This wireless Transceiver module is an easy and suitable module if you want to setup your wireless communication system with low cost!! This module can achieve a good balance between wireless transition performance and cost!
You can easily add it with your own MCU/ARM/PIC/AVR/STM32 system!


  1. 2Mbit/s, 1Mbit/s, 250Kbit/s, three selectable transmission rate.
  2. MultiCeiver hardware and six receiver functions.
  3. 2 Mbit/s make high-quality VoIP is possible.
  4. +/- 60 ppm crystal.
  5. Only require an external inductor in the antenna matching
  6. There is no need multi-layer PCB.
  7. 5V tolerance level inputs.
  8. Improved ShockBurst and the serial interface can be easy to connect with a variety of low-cost MCU.
  9. There si no need SPI interface with the MCU.
  10. Received in the rate of 2Mbit/s, the peak current is 12.5mA.
  11. When the rate of 2Mbit/s @ 0dBm output,the peak current is 11mA.
  12. Power-down mode, power consumption is 400nA.
  13. Standby mode, power consumption is 32uA.
  14. 130us fast switching and wake time.
  15. With voltage regulator:Oltage regulators on board.
  16. Built-in 2.4GHz antenna,support up to six channels of data reception.
  17. Low operating voltage: 1.9-3.6V
  18. Small size:15*29mm